Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › SFI SYSTEM
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273876 SFI SYSTEM L

1GR-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

Perform Reset Memory (A/T initialization) for 4WD when replacing the automatic transaxle assembly, engine assembly or ECM (See page Drivetrain>A750F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION).

·

Perform Reset Memory (A/T initialization) for 2WD when replacing the automatic transaxle assembly, engine assembly or ECM (See page Drivetrain>A750E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION).



HINT:

Initialization cannot be completed only by disconnecting and reconnecting the battery cable.



USING INTELLIGENT TESTER


CAUTION:

Observe the following items for safety reasons:


·

Read the intelligent tester instruction books before using the intelligent tester.

·

Make sure that the intelligent tester cable is not caught on the pedals, shift lever or steering wheel when driving with the intelligent tester connected to the vehicle.

·

When driving the vehicle for testing purposes while using the intelligent tester, two persons are required. One person drives the vehicle and the other operates the intelligent tester.



DISCONNECT AND RECONNECT CABLE OF NEGATIVE BATTERY TERMINAL


A168052E06
2.302,2.865 2.49,2.865 2.49,2.865 1.969,1.542 false 2.354,1.115 2.698,0.708 false 2.052,2.792 2.281,3 0.229,0.208 10 false *1 2.719,0.5 2.938,0.698 0.219,0.198 10 false *2

a.

Before performing electrical work, disconnect the cable from the negative (-) battery terminal in order to prevent short circuits and burnouts.

Text in Illustration
*1 Negative (-) Battery Terminal
*2 Cable


b.

Before disconnecting and reconnecting the battery cable, turn the ignition switch off and the headlight dimmer switch off. Then loosen the terminal nut completely. Do not damage the cable or terminal.


c.

When the battery cable is disconnected, the clock and radio settings and stored DTCs are cleared. Therefore, before disconnecting the battery cable, make a note of the settings.