Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › SFI SYSTEM
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273876 SFI SYSTEM C

1GR-FE ENGINE CONTROL  SFI SYSTEM  P0604  Internal Control Module Random Access Memory (RAM) Error  P0606  ECM / PCM Processor  P060A  Internal Control Module Monitoring Processor Performance  P060B  Internal Control Module A/D Processing Performance  P060D  Internal Control Module Accelerator Pedal Position Performance  P060E  Internal Control Module Throttle Position Performance  P0657  Actuator Supply Voltage Circuit / Open  P1607  Cruise Control Input Processor  


DESCRIPTION

The ECM continuously monitors its internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM stores the appropriate DTC and illuminates the MIL.

The ECM memory status is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and stores a DTC if: 1) outputs from the 2 CPUs are different or deviate from the standard, 2) the signals sent to the throttle actuator deviate from the standard, 3) a malfunction is found in the throttle actuator supply voltage, or 4) any other ECM malfunction is found.

DTC No. DTC Detection Condition Trouble Area
P0604
P0606
P060A
P060B
P060D
P060E
P0657
P1607
There is an ECM internal error (1 trip detection logic). ECM

CAUTION / NOTICE / HINT

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE

1.CHECK FOR ANY OTHER DTCS OUTPUT
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the intelligent tester on.


c.

Clear the DTCs.


d.

Turn the ignition switch off and turn the intelligent tester off.


e.

Disconnect the intelligent tester.


f.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


g.

Connect the cable to the negative (-) battery terminal.


h.

Connect the intelligent tester to the DLC3.


i.

Turn the ignition switch to ON and turn the intelligent tester on.


j.

Enter the following menus: Powertrain / Engine and ECT / DTC.


k.

Read the DTCs.


Result
Result Proceed to
DTC P0604, P0606, P060A, P060B, P060D, P060E, P0657 and/or P1607 is output A
DTC P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607 and other DTCs are output B
No DTC is output C


A

B

C