Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › DRIVE BELT
RM1440E _51 Engine / Hybrid System _056125 1GR-FE ENGINE MECHANICAL _0273878 DRIVE BELT A

1GR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.
A225650E04
2.573,1.073 2.313,1.073 true 0.323,0.76 0.51,0.948 0.188,0.188 10 false *1 1.438,0.75 1.625,0.938 0.188,0.188 10 false *2 0.865,1.083 1.052,1.271 0.188,0.188 10 false *3 2.333,0.531 2.521,0.719 0.188,0.188 10 false *3 3.104,0.635 3.292,0.823 0.188,0.188 10 false *4 2.875,1.49 3.063,1.677 0.188,0.188 10 false *5 2.208,1.583 2.396,1.771 0.188,0.188 10 false *6 1.427,1.469 1.615,1.656 0.188,0.188 10 false *7 2.635,0.99 2.823,1.177 0.188,0.188 10 false *8

Set the V belt onto every part.

Text in Illustration
*1 Vane Pump
*2 Water Pump
*3 No. 2 Idler
*4 Generator
*5 Cooler Compressor
*6 No. 1 Idler
*7 Crankshaft
*8 V-ribbed Belt Tensioner


b.

While turning the belt tensioner counterclockwise, remove the pin.

NOTICE:

Make sure that the V belt is properly installed to each pulley.



c.

Check that the belt fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.