Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › CANISTER › 2009.08–2014.08
RM1440E _51 Engine / Hybrid System _056127 1GR-FE EMISSION CONTROL _0273897 CANISTER G

1GR-FE EMISSION CONTROL  CANISTER  INSPECTION  


PROCEDURE

Hide 77704 1.INSPECT CANISTER

a.

Visually check the canister for cracks or damage.

If cracks or damage is found, replace the canister.


b.
A172207E05
2.333,0.719 2.865,0.188 2.865,0.188 3.01,0.188 false 1.427,0.281 0.948,0.156 0.948,0.156 0.865,0.156 false 1.531,0.979 0.927,0.531 0.927,0.531 0.854,0.531 true 3.01,0.104 3.208,0.26 0.198,0.156 10 false *3 0.667,0.458 0.865,0.615 0.198,0.156 10 false *1 0.635,0.063 0.833,0.219 0.198,0.156 10 false *2

Using SST, inspect the canister.

SST
09992-00242  

OK:
Measurement Condition Specified Condition
Ports B and C closed, vacuum applied to port A [1.96 kPa (15 mmHg, 0.579 in.Hg)] No leak
Port C closed, vacuum applied to port A [1.96 kPa (15 mmHg, 0.579 in.Hg)] Air flows from port B
Port C closed, air blow into port A [4.71 kPa (0.05 kgf/cm2, 0.7 psi)] Air flows from port B
Air blow into port A [4.71 kPa (0.05 kgf/cm2, 0.7 psi)] Air flows from both ports B and C


Text in Illustration
*1 Port A
*2 Port B
*3 Port C

If the result is not as specified, replace the canister.