Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › CANISTER › from 2014.08
RM1440E _51 Engine / Hybrid System _056127 1GR-FE EMISSION CONTROL _0273897 CANISTER A

1GR-FE EMISSION CONTROL  CANISTER  REMOVAL  


PROCEDURE

Hide 77704 1.REMOVE CANISTER (w/o Secondary Air Injection System)

a.
A223582

Disconnect the purge line hose from the canister.


b.

Disconnect the vent line hose from the canister.


c.

Disconnect the air inlet line hose from the canister.


d.
A223583

Remove the canister from the bracket.


Hide 2.REMOVE SPARE TIRE (w/ Secondary Air Injection System)

Hide 77740 3.REMOVE CANISTER ASSEMBLY (w/ Secondary Air Injection System)

a.
A225429E04
0.573,1.948 0.729,2.135 0.156,0.188 10 false *1 2.063,1.969 2.219,2.156 0.156,0.188 10 false *2 2.656,2.063 2.813,2.25 0.156,0.188 10 false *3

Disconnect the canister pump module connector.


b.

Disconnect the purge line hose.

Text in Illustration
*1 Vent Line Hose
*2 Air Inlet Line Hose
*3 Canister
V100136

Pull Out
V100137

Pinch


c.

Disconnect the air inlet line hose.

i.

Push the hose firmly toward the canister side.


ii.

Pinch the hose as shown in the illustration.


iii.

Pull out the hose.

NOTICE:
·

Do not use any tools in this procedure.

·

Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the canister and hose.





d.

Disconnect the vent line hose.

i.

Pinch the retainer and then raise it.

NOTICE:
·

Do not use any tools in this procedure.

·

Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.





e.
A225361

Detach the claw, and remove the 3 bolts and canister assembly.