Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › AIR PUMP › from 2014.08
RM1440E _51 Engine / Hybrid System _056127 1GR-FE EMISSION CONTROL _0273901 AIR PUMP G

1GR-FE EMISSION CONTROL  AIR PUMP  INSPECTION  


PROCEDURE

Hide 17610C 1.INSPECT AIR PUMP ASSEMBLY

a.

Check the heater resistance.

i.
A334612E02
2,0.771 2.292,0.479 true 2.292,1.729 2,1.438 true 0.115,0.104 0.427,0.333 0.313,0.229 10 false *a 2.333,0.333 2.927,0.563 0.594,0.229 10 false APH+ 2.375,1.677 2.969,1.906 0.594,0.229 10 false APHG

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (APH+) - 3 (APHG) -20°C (-4°F) 3.6 to 17.6 Ω
-10°C (14°F) 3.4 to 16.5 Ω
0°C (32°F) 3.1 to 15.4 Ω
10°C (50°F) 2.8 to 14.3 Ω
20°C (68°F) 2.7 to 13.2 Ω


Text in Illustration
*a Component without harness connected
(Air pump assembly)

If the result is not as specified, replace the air pump assembly.