Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › AIR SWITCHING VALVE(for Bank 1) › from 2014.08
RM1440E _51 Engine / Hybrid System _056127 1GR-FE EMISSION CONTROL _0273902 AIR SWITCHING VALVE(for Bank 1) G

1GR-FE EMISSION CONTROL  AIR SWITCHING VALVE(for Bank 1)  INSPECTION  


PROCEDURE

Hide 25701 1.INSPECT NO. 1 EMISSION CONTROL VALVE SET

a.
A289395E02
0.094,0.073 0.344,0.344 0.25,0.271 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 5 20°C (68°F) 4.5 to 5.5 Ω
1 - Body ground Always 1 MΩ or higher
5 - Body ground


Text in Illustration
*a Component without harness connected
(No. 1 Emission Control Valve Set)

HINT:
·

When measuring the resistance, do not touch terminals 2, 3 or 4.

·

When measuring the resistance, make sure that the surface temperature of the No. 1 emission control valve set is 20°C.



If the result is not as specified, replace the No. 1 emission control valve set.


b.
A224403E03
3.177,1.729 3.104,1.729 3.104,1.729 2.917,1.958 false 2.76,1.344 2.656,1.344 2.656,1.344 2.427,1.688 false 1.083,2.417 1.083,2.917 true 3.229,1.656 3.406,1.813 0.177,0.156 10 false *1 1,2.958 1.177,3.115 0.177,0.156 10 false *3 2.802,1.271 2.979,1.427 0.177,0.156 10 false *2

Check the operation of the No. 1 emission control valve set.

i.

Check that air does not flow from port A to port B.

Text in Illustration
*1 Air
*2 Port A
*3 Port B

NOTICE:

Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.


If the result is not as specified, replace the No. 1 emission control valve set.


ii.
A289396E03
2.677,2.813 2.563,2.813 2.563,2.813 2.354,3.271 false 1.021,3.99 1.156,4.406 1.156,4.406 1.344,4.406 true 3.052,3.198 2.969,3.198 2.969,3.198 2.823,3.542 false 3.083,3.104 3.313,3.313 0.229,0.208 10 false *1 2.719,2.74 2.948,2.948 0.229,0.208 10 false *2 1.406,4.323 1.635,4.5 0.229,0.177 10 false *3

Apply battery voltage across terminals 1 and 5.

NOTICE:

When applying voltage, do not touch terminals 2, 3 or 4.



iii.

Check that air flows from port A to port B.

Text in Illustration
*1 Air
*2 Port A
*3 Port B

If the result is not as specified, replace the No. 1 emission control valve set.