Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › AIR SWITCHING VALVE(for Bank 2) › from 2014.08
RM1440E _51 Engine / Hybrid System _056127 1GR-FE EMISSION CONTROL _0273903 AIR SWITCHING VALVE(for Bank 2) A

1GR-FE EMISSION CONTROL  AIR SWITCHING VALVE(for Bank 2)  INSTALLATION  


PROCEDURE

Hide 25702B 1.INSTALL NO. 2 EMISSION CONTROL VALVE SET

a.

Install the No. 2 emission control valve set with the 3 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


b.
A288452E04
1.26,0.208 1.125,0.208 1.125,0.208 0.969,0.771 true 0.385,1.25 0.51,1.25 0.51,1.25 0.708,0.813 true 0.188,1.177 0.406,1.365 0.219,0.188 10 false *1 1.281,0.125 1.5,0.313 0.219,0.188 10 false *2 2.448,0.167 2.667,0.354 0.219,0.188 10 false *a 3.073,0.615 3.271,0.802 0.198,0.188 10 false *b 2.969,0.938 3.302,1.125 0.333,0.188 10 false 60°

Align the paint mark with the projection and connect the No. 3 air hose.

Text in Illustration
*1 Paint Mark
*2 Projection
*a Upper
*b LH Side

HINT:

Make sure the direction of the hose clamp is as shown in the illustration.



c.

Connect the No. 2 emission control valve set connector.


Hide 17362 2.INSTALL NO. 2 AIR TUBE

a.
A289303E03
2.531,0.917 2.615,1.073 2.615,1.073 2.677,1.073 false 2.885,0.708 2.969,0.854 2.969,0.854 3.031,0.854 false 2.719,1 2.917,1.177 0.198,0.177 10 false *1 3.073,0.771 3.271,0.948 0.198,0.177 10 false *2

Install 2 new gaskets to the No. 2 air tube.

Text in Illustration
*1 New Gasket
*2 No. 2 Air Tube

NOTICE:

Be careful not to damage the installation surfaces of the gaskets.



b.

Install the No. 2 air tube with the 2 bolts and 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)