Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › EXHAUST PIPE › 2009.08–2013.08
RM1440E _51 Engine / Hybrid System _056128 1GR-FE INTAKE / EXHAUST _0273908 EXHAUST PIPE A

1GR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 76625G 1.REMOVE REAR QUARTER PANEL MUDGUARD RH (for X-Runner)

Hide 76625G 2.REMOVE REAR QUARTER PANEL MUDGUARD RH

Hide 52185A 3.REMOVE REAR BUMPER SIDE BRACKET RH (for X-Runner)

a.
A224825

Remove the 3 screws, clip and rear bumper side bracket RH.


Hide 52185A 4.REMOVE REAR BUMPER SIDE BRACKET RH

a.
A224827

Remove the 3 screws, clip and rear bumper side bracket RH.


Hide 17430 5.REMOVE TAILPIPE ASSEMBLY

a.

Remove the 2 bolts and disconnect the tailpipe from the exhaust pipe support.


b.

Remove the gasket and exhaust pipe support.


Hide 17420 6.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 2 bolts and 2 compression springs, and then disconnect the center exhaust pipe from the 3 exhaust pipe supports.


b.

Remove the gasket.


Hide 17410 7.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the 2 nuts and front exhaust pipe.


c.

Remove the gasket.


Hide 17548 8.REMOVE EXHAUST PIPE STOPPER BRACKET

a.

Remove the 2 bolts and stopper bracket.


Hide 17450B 9.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the 2 nuts and front exhaust pipe.


c.

Remove the gasket.


Hide 89465 10.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 89465 11.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)