Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › EXHAUST PIPE › from 2013.08
RM1440E _51 Engine / Hybrid System _056128 1GR-FE INTAKE / EXHAUST _0273908 EXHAUST PIPE A

1GR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 51450 1.REMOVE REAR ENGINE UNDER COVER ASSEMBLY

Hide 76625G 2.REMOVE REAR QUARTER PANEL MUDGUARD RH (w/o TOYOTA Parking Assist-sensor System)

a.

Remove the 3 clips, 6 screws and rear quarter panel mudguard RH.


Hide 76625G 3.REMOVE REAR QUARTER PANEL MUDGUARD RH (w/ TOYOTA Parking Assist-sensor System)

a.

Remove the 4 clips, 4 screws and rear quarter panel mudguard RH.


Hide 52185A 4.REMOVE REAR BUMPER SIDE BRACKET RH (w/o TOYOTA Parking Assist-sensor System)

a.
A313866E02
1.948,0.385 1.792,0.385 1.792,0.385 1.583,1.208 true 2,0.323 2.167,0.479 0.167,0.156 10 false *1

Remove the clip and 3 screws.

Text in Illustration
*1 Guide


b.

Detach the guide and remove the rear bumper side bracket RH.


Hide 52185A 5.REMOVE REAR BUMPER SIDE BRACKET RH (w/ TOYOTA Parking Assist-sensor System)

a.
A224825E02
2.625,1.031 2.49,1.031 2.49,1.031 2.292,1.552 true 2.656,0.958 2.823,1.125 0.167,0.167 10 false *1

Remove the clip and 3 screws.

Text in Illustration
*1 Guide


b.

Detach the guide and remove the rear bumper side bracket RH.


Hide 17430 6.REMOVE TAILPIPE ASSEMBLY

a.

Remove the 2 bolts and disconnect the tailpipe assembly from the exhaust pipe support.


b.

Remove the gasket and exhaust pipe support.


Hide 17420 7.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 2 bolts and 2 compression springs, and then disconnect the center exhaust pipe assembly from the 4 exhaust pipe supports.


b.

Remove the gasket and 4 exhaust pipe supports.


Hide 17410 8.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the 2 bolts, 2 nuts and front exhaust pipe assembly.


c.

Remove the gasket.


Hide 17548 9.REMOVE EXHAUST PIPE STOPPER BRACKET (for 4WD)

a.

Remove the 2 bolts and exhaust pipe stopper bracket.


Hide 17450B 10.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the 2 nuts and disconnect the front No. 2 exhaust pipe assembly from the exhaust pipe support.


c.

Remove the 2 gaskets and exhaust pipe support.


Hide 89465 11.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 89465 12.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)