Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER
RM1440E _51 Engine / Hybrid System _056131 1GR-FE STARTING _0273920 STARTER A

1GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 17105 2.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.

Remove the exhaust manifold sub-assembly LH (See page Engine / Hybrid System>1GR-FE INTAKE / EXHAUST>EXHAUST MANIFOLD>REMOVAL).


Hide 28192 3.REMOVE STARTER COVER

a.
A222904

Remove the 3 bolts and starter cover.


Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A222905

Remove the bolt and disconnect the ground wire.


b.

Disconnect the starter connector.


c.

Open the terminal cap.


d.

Remove the nut and bolt, and then disconnect the starter wire.


e.
A218197

Remove the 2 bolts and starter.


Hide 11363A 5.REMOVE FLYWHEEL HOUSING SIDE COVER

A222907