Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER
RM1440E _51 Engine / Hybrid System _056131 1GR-FE STARTING _0273920 STARTER A

1GR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28120 1.REMOVE STARTER YOKE ASSEMBLY

a.
A219637

Remove the nut and disconnect the lead wire from terminal C.


b.

Remove the 2 bolts.


c.

Pull out the starter yoke and starter commutator end frame together with the starter armature.


d.

Remove the O-ring from the starter yoke.


Hide 28150 2.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A219638

Remove the 2 bolts and magnet starter switch.


b.
A219639E06
0.594,0.677 0.698,0.833 0.698,0.833 0.792,0.833 false 0.958,0.563 1.073,0.813 1.073,0.813 1.188,0.813 false 1.365,0.49 1.552,0.708 1.552,0.708 1.677,0.708 false 0.406,1.802 0.49,1.229 0.49,1.229 0.615,1.229 false 1.427,1.344 1.49,1.031 1.49,1.031 1.625,1.031 false 2.563,1.656 2.438,1.885 2.438,1.885 2.302,1.885 false 0.833,0.76 1.146,0.958 0.313,0.198 10 false *6 1.24,0.729 1.552,0.927 0.313,0.198 10 false *5 1.75,0.615 2.063,0.813 0.313,0.198 10 false *4 0.656,1.135 0.969,1.333 0.313,0.198 10 false *3 1.667,0.948 1.979,1.146 0.313,0.198 10 false *2 2.125,1.802 2.438,2 0.313,0.198 10 false *1

Remove the idle gear, retainer, clutch roller, return spring and starter clutch from the starter drive housing.

Text in Illustration
*1 Starter Drive Housing
*2 Starter Clutch
*3 Return Spring
*4 Idle Gear
*5 Retainer
*6 Clutch Roller


c.
A388223E01
1.865,1.594 1.865,1.052 1.865,1.052 2.073,0.844 false 1.802,1.646 2.115,1.844 0.313,0.198 10 false *1

Using a magnet hand, remove the steel ball from the starter clutch hole.

Text in Illustration
*1 Magnet Hand


Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A219640

Remove the 2 screws, and then remove the commutator end frame from the starter yoke.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame.



b.

Remove the dust starter protector from the commutator end frame.


c.

Remove the O-ring from the starter yoke.


d.
A215926

Disconnect the 4 brushes from the starter brush holder.

i.

Using a screwdriver, hold back the brush spring.


ii.

Disconnect the brush from the starter brush holder.



e.

Remove the starter brush holder.


Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.

Remove the starter armature from the starter yoke.