Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER
RM1440E _51 Engine / Hybrid System _056131 1GR-FE STARTING _0273920 STARTER A

1GR-FE STARTING  STARTER  REASSEMBLY  


PROCEDURE

Hide 28160 1.INSTALL STARTER ARMATURE ASSEMBLY

a.

Install the starter armature to the starter yoke.


Hide 28140 2.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.

Install the starter brush holder.


b.
A215926

Connect the 4 brushes to the starter brush holder.

i.

Using a screwdriver, hold back the brush spring.


ii.

Connect the brush to the starter brush holder.

NOTICE:

Check that the positive (+) lead wires are not grounded.




c.

Place a new O-ring in position on the commutator end frame.


d.

Install a new dust starter protector to the commutator end frame.


e.

Install the commutator end frame with the 2 screws.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


Hide 28150 3.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.

Apply high-temperature grease to the idle gear, steel ball, return spring, clutch roller and retainer.


b.
A222255

Insert the steel ball into the starter clutch.


c.

Insert the return spring into the starter clutch.


d.

Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.


e.

Install the starter drive housing to the magnet starter switch with the 2 bolts.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


Hide 28120 4.INSTALL STARTER YOKE ASSEMBLY

a.

Install a new O-ring to the groove of the starter yoke.


b.
A218208E06
2.135,1.198 2.438,0.781 2.438,0.781 2.521,0.781 true 1.167,0.792 0.979,0.667 0.979,0.667 0.917,0.667 true 2.563,0.719 2.74,0.896 0.177,0.177 10 false *1 0.719,0.583 0.917,0.76 0.198,0.177 10 false *2

Align the claw of the starter yoke with the groove of the starter switch.

Text in Illustration
*1 Claw
*2 Groove


c.

Install the starter yoke to the magnet starter switch with the 2 bolts.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


d.

Connect the lead wire to terminal C with the nut.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)