Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM1440E _51 Engine / Hybrid System _056132 CRUISE CONTROL _0273923 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0503  Vehicle Speed Sensor Circuit Malfunction  


DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.

DTC Code DTC Detection Condition Trouble Area
P0503 A malfunction in the vehicle speed signal is detected while cruise control is in operation.
·

Vehicle stability control system

·

Vehicle speed sensor signal circuit

·

Vehicle speed sensor

·

Combination meter assembly

·

ECM



PROCEDURE

1.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

Vehicle stability control system DTCs are not output.




OK

2.CHECK FOR DTC

NG

2.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 40 km/h (25 mph) or more.


ii.

Turn the cruise control switch on.


iii.

Push the cruise control switch to -SET to activate cruise control.



c.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTC P0503 is not output.




OK

NG