Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE
RM1440E _52 Drivetrain _056134 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0273941 TRANSMISSION WIRE A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  REMOVAL  


PROCEDURE

Hide 1.DRAIN AUTOMATIC TRANSMISSION FLUID

a.

Remove the drain plug and gasket, and drain the ATF.


b.

Install a new gasket and the drain plug.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 35106 2.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

a.
U148188

Remove the 20 bolts, oil pan and gasket from the transmission.

NOTICE:

Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.



b.

Examine the particles in the pan.

i.

Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

Steel (magnetic): bearing, gear and clutch plate wear

Brass (non-magnetic): bush wear



Hide 35330 3.REMOVE VALVE BODY OIL STRAINER ASSEMBLY

a.
D028692

Remove the 4 bolts and oil strainer.

NOTICE:

Be careful as some fluid may leak out of the oil strainer.



b.

Remove the O-ring from the oil strainer.


Hide 82125J 4.DISCONNECT TRANSMISSION WIRE

C125285

a.

Remove the 2 bolts and 2 temperature sensor clamps.


b.

Disconnect the 2 ATF temperature sensors.


c.

Disconnect the 7 connectors from the solenoid valves.


Hide 82125J 5.REMOVE TRANSMISSION WIRE

U148191

a.

Disconnect the wire connector.

i.

Detach the claw, press down the lever, and then disconnect the transmission wire connector.



b.
C125286

Remove the bolt and pull out the transmission wire.