Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP
RM1440E _52 Drivetrain _056134 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0273951 OIL PUMP G

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  INSPECTION  


PROCEDURE

Hide 35301 1.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

a.
D027954

Using a dial indicator, measure the inside diameter of the oil pump body bush.

Maximum inside diameter:

38.188 mm (1.50 in.)


If the inside diameter is more than the maximum, replace the oil pump body sub-assembly.



Hide 35370 2.INSPECT STATOR SHAFT ASSEMBLY

a.
D027955

Using a dial indicator, measure the inside diameter of the stator shaft bush.

Maximum inside diameter:
Front side:

21.577 mm (0.849 in.)

Rear side:

32.08 mm (1.26 in.)


If the inside diameter is more than the maximum, replace the stator shaft assembly.



Hide 3.INSPECT CLEARANCE OF OIL PUMP ASSEMBLY

a.
D027956

Push the driven gear to one side of the body.


b.

Using a feeler gauge, measure the body clearance.

Standard body clearance:

0.10 to 0.17 mm (0.00394 to 0.00669 in.)


Maximum body clearance:

0.17 mm (0.00669 in.)


If the body clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly. Replace the part or parts determined to be the most likely cause of the problem.



c.
D027957

Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.

Standard tip clearance:

0.070 to 0.150 mm (0.00276 to 0.00591 in.)


Maximum tip clearance:

0.150 mm (0.00591 in.)


If the tip clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly. Replace the part or parts determined to be the most likely cause of the problem.



d.
D001286

Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

Standard side clearance:

0.02 to 0.05 mm (0.000787 to 0.00197 in.)


Maximum side clearance:

0.05 mm (0.00197 in.)


If the side clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly. Replace the part or parts determined to be the most likely cause of the problem.

HINT:

There are 5 different drive and driven gear thicknesses.


Drive and Driven Gear Thickness:
Mark Thickness
0 10.74 to 10.749 mm (0.42283 to 0.42319 in.)
1 10.75 to 10.759 mm (0.42323 to 0.42358 in.)
2 10.76 to 10.77 mm (0.42362 to 0.42401 in.)
3 10.771 to 10.78 mm (0.42405 to 0.42441 in.)
4 10.781 to 10.79 mm (0.42445 to 0.42480 in.)



Hide 35321 4.INSPECT FRONT OIL PUMP DRIVE GEAR ROTATION

D027962

a.

Place the oil pump body on the torque converter clutch.


b.

Check that the drive gear rotates smoothly.


c.

Remove the oil pump assembly from the torque converter clutch.