1.CHECK TRANSFER OIL
Remove the filler plug and gasket.
Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
If the result is not as specified, add transfer oil.
| *a | 0 to 5 mm |
Too much or too little oil will lead to transfer problems.
When the oil level is too low, check for oil leaks.
Install a new gasket to the filler plug and then tighten the plug.
2.ADD TRANSFER OIL
Remove the filler plug and gasket.
Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
Add oil slowly.
Add oil a little at a time, waiting several minutes between each addition of oil.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket to the filler plug and then tighten the plug.