Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM1440E _52 Drivetrain _056136 DRIVE SHAFT / PROPELLER SHAFT _0273960 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 43448G 1.REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP

a.

Hold the drive shaft lightly in a vise between aluminum plates.


b.
C108564

Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration.


Hide 43448F 2.REMOVE FRONT NO. 1 AXLE INBOARD JOINT BOOT CLAMP

a.

Remove the front axle inboard joint boot clamp.

HINT:

Perform the same procedures described for the front No. 2 axle inboard joint boot clamp.



Hide 3.REMOVE FRONT AXLE INBOARD JOINT BOOT

Hide 43403B 4.REMOVE FRONT AXLE INBOARD JOINT ASSEMBLY

a.
FA01615E11
1.688,0.667 1.146,0.219 1.146,0.219 1.927,0.396 false 0.969,0.115 1.208,0.354 0.24,0.24 10 false *a

Place matchmarks on the tripod and the inboard and outboard joint shafts.

Text in Illustration
*a Matchmark

NOTICE:

Do not punch the marks.



b.

Remove the inboard joint from the outboard joint shaft.


c.
G022501

Using a snap ring expander, remove the snap ring.


d.
N000194E18
1.688,1.74 1.854,1.896 0.167,0.156 10 false *a

Place matchmarks on the outboard joint shaft and tripod.

Text in Illustration
*a Matchmark

NOTICE:

Do not punch the marks.



e.

Using a brass bar and hammer, remove the tripod from the drive shaft.

NOTICE:

Do not tap the roller.



Hide 43447F 5.REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP

a.
C063445

Using a screwdriver, remove the outboard joint boot clamps.

HINT:

If the outboard joint boot clamps that have been replaced are installed to the drive shaft, use a side cutter to remove them.



Hide 43447E 6.REMOVE FRONT NO. 1 AXLE OUTBOARD JOINT BOOT CLAMP

C081566

a.

Using pliers, remove the boot clamp as shown in the illustration.


Hide 7.REMOVE OUTBOARD JOINT BOOT

Hide 43412B 8.REMOVE SHAFT SNAP RING

C057543

a.

Using a screwdriver, remove the snap ring.


Hide 41336E 9.REMOVE FRONT DRIVE SHAFT DUST COVER

F040647E20
1.958,0.823 2.417,0.365 false 2.49,0.25 2.823,0.417 0.333,0.167 10 false SST

a.

Using SST and a press, remove the dust cover.

SST
09950-00020