Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY
RM1440E _52 Drivetrain _056136 DRIVE SHAFT / PROPELLER SHAFT _0273962 FRONT PROPELLER SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 37110 1.INSPECT FRONT PROPELLER SHAFT ASSEMBLY

a.
C029928

Using a dial indicator, check the propeller shaft runout.

Maximum runout:

0.3 mm (0.0118 in.)


If the shaft runout is more than maximum, replace the propeller shaft.


Hide 2.INSPECT FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

a.

Check the spider bearings for wear or damage.

If necessary, replace the spider bearing.


b.
C172298

Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0.0 mm (0 in.)


If the axial play is more than the maximum, replace the spider bearing.