Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY(for 4WD)
RM1440E _52 Drivetrain _056136 DRIVE SHAFT / PROPELLER SHAFT _0273964 PROPELLER SHAFT ASSEMBLY(for 4WD) G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY(for 4WD)  INSPECTION  


PROCEDURE

Hide 37110 1.INSPECT PROPELLER SHAFT ASSEMBLY

a.
C061260

Using a dial indicator, check the propeller shaft runout.

Maximum runout:

0.4 mm (0.0157 in.)


If the shaft runout is more than maximum, replace the shaft.


Hide 2.INSPECT REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

NOTICE:

Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.


a.

Check the spider bearings for wear or damage.

If necessary, replace the spider bearing.


b.
C175289

Check the spider bearing axial play by turning the yoke with holding the shaft tightly.

Maximum bearing axial play:

0 mm(0 in.)


If the axial play is more than the maximum, replace the spider bearing.