Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY(for 4WD)
RM1440E _52 Drivetrain _056136 DRIVE SHAFT / PROPELLER SHAFT _0273964 PROPELLER SHAFT ASSEMBLY(for 4WD) A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY(for 4WD)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

HINT:

Use the same procedure for all rear propeller shaft universal joint spider bearing.


a.
F015023E18
1.844,0.958 2.323,0.292 2.323,0.292 1.979,0.99 false 2.344,0.219 2.594,0.385 0.25,0.167 10 false *1

Place matchmarks on the flange yoke and sleeve yoke.

Text in Illustration
*a Matchmark


b.
C061264

Using a brass bar and a hammer, slightly tap in the spider bearing outer races.


c.

Using 2 screwdrivers, remove the 4 snap rings from the grooves.


d.
F015025E18
2.188,1.479 2.49,1.188 true 0.438,1.021 1.146,1.021 false 0.135,0.938 0.406,1.115 0.271,0.177 10 true SST 2.083,1.448 2.208,1.625 0.125,0.177 10 true A

Using SST, remove the spider bearing from the sleeve yoke.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.



e.
F044192E11
2.333,0.719 2.948,1.313 false 2.927,1.344 3.167,1.521 0.24,0.177 10 false *a

Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

Text in Illustration
*a Hammering Point

HINT:

Remove the spider bearing on opposite side in the same procedure.


NOTICE:

Do not tap the shaft.



f.
F015030E15
0.479,1.188 0.938,1.083 false 1.74,0.781 2.531,1.042 false 0.167,1.125 0.469,1.292 0.302,0.167 10 false SST 1.583,0.677 1.813,0.844 0.229,0.167 10 false A

Install the 2 removed spider bearing outer races to the universal joint spider.


g.

Using SST, remove the bearing from the yoke.

SST
09332-25010  

HINT:

Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.



h.
F044193E12
1.635,0.292 2.427,0.594 false 1.438,0.198 1.635,0.375 0.198,0.177 10 false *a

Clamp the outer bearing race in a vise between aluminum plates and tap off the yoke with a hammer.

Text in Illustration
*a Hammering Point


i.

Remove the universal joint spider.