Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER
RM1440E _53 Suspension _056139 FRONT SUSPENSION _0273982 FRONT SHOCK ABSORBER A

FRONT SUSPENSION  FRONT SHOCK ABSORBER  REASSEMBLY  


PROCEDURE

Hide 48510H 1.INSTALL FRONT SHOCK ABSORBER BUSH

a.
C214442E01
2.777,1.165 3.125,1.453 0.348,0.288 10 SST 2.114,0.689 2.547,0.689 false 2.547,0.689 2.547,1.886 false 2.547,1.886 2.204,1.886 false 2.547,1.245 2.747,1.245 false

Using SST and a press, install a new absorber bush.

SST
09710-30012  (09710-04071, 09710-04081)


Hide 48132 2.INSTALL FRONT COIL SPRING LH

a.
C159782E02
0.115,0.613 0.414,0.758 0.3,0.145 10 SST 0.464,0.688 0.688,0.688 false 0.688,0.688 0.727,0.793 false

Using SST, compress the coil spring.

SST
09727-30021  (09727-00010, 09727-00031)
09727-00060  

NOTICE:
·

Do not compress the coil spring more than necessary.

·

Do not use an impact wrench. It will damage SST.




b.
C155966E07
2.708,0.427 2.813,1.073 2.813,1.073 2.813,1.344 false 0.708,1.083 0.479,1.083 false 0.146,1.01 0.521,1.198 0.375,0.188 10 false SST 2.729,1.385 2.938,1.583 0.208,0.198 10 false *a

Install the coil spring to the shock absorber.

HINT:

Fit the lower end of the coil spring into the recess of the spring seat of the shock absorber.


Text in Illustration
*a Lower End


Hide 48609 3.INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH

a.

Install the cushion, 2 retainers and suspension support to the piston rod.


b.

Temporarily install a new front shock absorber nut to the suspension support.


c.
U115989E02
1.208,1.208 1.698,1.354 1.698,1.354 1.698,1.51 false 0.958,1.656 0.958,1.813 false 0.292,0.198 0.552,0.417 0.26,0.219 10 false *A 2.917,0.208 3.177,0.427 0.26,0.219 10 false *B 1.615,1.552 1.813,1.719 0.198,0.167 10 false *1 0.875,1.833 1.146,2.042 0.271,0.208 10 false *2

Position the suspension support as shown in the illustration.

Text in Illustration
*A LH
*B RH
*1 Absorber Bush
*2 Suspension Support Sub-assembly
V100135

Front


d.

Remove SST.

HINT:

Release the coil spring while checking the position of the suspension support.


NOTICE:

Do not use an impact wrench. It will damage the shock absorber rod.



Hide 48680A 4.TIGHTEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

a.

Tighten a new nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)