43324C
1.INSTALL FRONT UPPER BALL JOINT DUST COVER LH
Pack the upper arm ball joint with MP grease.
8.0 g (0.282 oz.)
| *1 | MP Grease |
Apply MP grease to the locations shown in the illustration.
Do not apply MP grease to the tapered or threaded parts of the ball joint.
Install the dust cover to the upper arm.
Using a snap ring expander, install the dust cover set ring.
Make sure the set ring is securely installed in the groove.
48632B
2.INSTALL FRONT SUSPENSION UPPER ARM BUSH LH
Using SST and a press, press in a new bush.
Press in the rear side bush using the same procedure as for the front side.