Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM1440E _53 Suspension _056139 FRONT SUSPENSION _0273984 FRONT LOWER SUSPENSION ARM G

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  INSPECTION  


PROCEDURE

Hide 48069 1.INSPECT FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH

a.
G021680

As shown in the illustration, flip the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take a torque reading on the 5th turn.

Standard turning torque:

0.29 to 2.94 N*m (2.96 to 30.0 kgf*cm, 2.57 to 26.02 in.*lbf) or less