Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.DISCONNECT FRONT SHOCK ABSORBER WITH COIL SPRING
Remove the bolt, nut and washer.
Disconnect the front shock absorber with coil spring from the suspension lower arm.
48069
3.REMOVE FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH
Remove the 2 bolts and disconnect the front lower ball joint attachment LH from the steering knuckle.
Place matchmarks on the No. 2 camber adjust cam and toe adjust cam sub-assembly.
| *a | Matchmark |
Remove the nut, No. 2 camber adjust cam, camber adjust cam assembly, bolt, toe adjust cam sub-assembly, No. 2 toe adjust plate and front No. 1 suspension lower arm sub-assembly LH.
Remove the cotter pin and nut.
Using SST, remove the front lower ball joint attachment LH.