Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM1440E _53 Suspension _056139 FRONT SUSPENSION _0273985 FRONT STABILIZER BAR G

FRONT SUSPENSION  FRONT STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY LH

a.
G021679

As shown in the illustration, flip the ball joint stud back and forth 5 times.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take a torque reading on the 5th turn.

Standard turning torque:

0.05 to 1.96 N*m (0.51 to 20 kgf*cm, 0.44 to 17.3 in.*lbf) or less



c.

Check for cracks and grease leaks on the ball joint dust cover.