Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM1440E _53 Suspension _056140 REAR SUSPENSION _0273987 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48540 1.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.

Install the cushion No. 2 to the rear shock absorber assembly LH.


b.

Temporarily install the cushion No. 1 and rear shock absorber assembly LH with a new nut.


c.

Temporarily install the rear shock absorber assembly LH with the bolt.


d.

Tighten the nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 2.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 3.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Bounce the vehicle up and down several times to stabilize the suspension.


Hide 48540 4.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the bolt.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)