Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE LINE
RM1440E _54 Brake _056143 BRAKE SYSTEM (OTHER) _0274005 BRAKE LINE L

BRAKE SYSTEM (OTHER)  BRAKE LINE  PRECAUTION  


CAUTION:

Make sure to replace each part properly. Improper installation or repair could affect the performance of the brake system and cause a driving hazard.


NOTICE:
·

It is very important to keep the brake system parts and the area clean when repairing the brake system.

·

Since the brake line is one of the critical safety-related parts, be sure to disassemble the components if a brake fluid leak is found. If any abnormality is found, replace the component with a new one.

·

When removing brake components, cover the brake tube connections to prevent foreign matter such as dust or dirt from entering the tubes.

·

Do not damage or deform the brake tubes when removing or installing them.

·

When installing a brake tube or flexible hose, make sure that it is not twisted or bent.

·

If the fitting of the flexible hose does not match the groove on the bracket, twist the hose slightly to insert it.

·

Flexible hoses must be free from absorber oil, grease, etc.

·

When installing a brake tube to a plastic clamp, make sure that the brake tube is not loose or pinched.

·

Do not reuse a clip removed from a flexible hose.

·

After installing a brake tube or flexible hose, make sure that it dose not interfere with any other components.

·

Do not allow brake fluid to adhere to any painted surface such as the vehicle body. If brake fluid leaks onto any painted surface, immediately wash it off.

·
C361898E01
1.292,4.083 1.292,3.219 false 2.938,2.219 3.094,2.219 3.094,2.219 3.094,1.031 false 0.167,0.333 0.479,0.531 0.313,0.198 10 false *a 0.156,2.563 0.469,2.76 0.313,0.198 10 false *b 2.74,2.135 3.052,2.333 0.313,0.198 10 false *1 1.208,4.156 1.521,4.354 0.313,0.198 10 false *1

Text in Illustration
*1 Union Nut Wrench
*a Disconnecting
*b Connecting

Follow these procedures when disconnecting the flexible hose and brake tube.

1.

Remove the clip.

2.

Hold the flexible hose with a wrench. Using a union nut wrench, disconnect the brake tube without deforming the tube.


·

Follow these procedures when connecting the flexible hose and brake tube.

1.

Hold the flexible hose with a wrench. Using a union nut wrench, connect the brake tube without deforming the tube.

2.

Install a new clip.


·
C217633

Follow these procedures when connecting the brake tube and 2-way.

1.

Connect the brake tubes to the 2-way and temporarily install the flare nuts of the brake tubes.

2.

Support the 2-way to prevent deformation to the brake tubes and install the bolt to fix the 2-way to the frame.

3.

Support the 2-way to prevent deformation to the brake tubes and tighten the flare nuts of the brake tubes to the torque specification with a union nut wrench.

4.

Connect the clamp to the brake tubes and 2-way with the 2 bolts.