Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM1440E _54 Brake _056144 BRAKE (FRONT) _0274011 FRONT BRAKE G

BRAKE (FRONT)  FRONT BRAKE  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust or scoring.

If necessary, replace the disc brake cylinder assembly.


Hide 2.INSPECT PAD LINING THICKNESS

a.
F042679

Using a ruler, measure the pad lining thickness.

Standard thickness:

11.3 mm (0.445 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the pad lining thickness is less than the minimum, replace the pad.


Hide 3.INSPECT DISC THICKNESS

a.
F042680

Using a micrometer, measure the disc thickness.

Standard thickness:

32.0 mm (1.26 in.)


Minimum thickness:

29.0 mm (1.14 in.)


If the disc thickness is less than the minimum, replace the disc.


Hide 4.INSPECT DISC RUNOUT

a.
C191821

Install the disc with the 6 hub nuts.

Torque:
112 N*m (1137 kgf*cm, 82 ft.*lbf)


b.

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.

Maximum disc runout:

0.05 mm (0.00197 in.)


If the disc runout is more than the maximum, check the bearing play in the axial direction and the axle hub runout (See page Drivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB(for 2WD)>ON-VEHICLE INSPECTION). If the bearing play and axle hub runout are normal, adjust the disc runout or grind the disc using an "On-car" brake lathe.


c.

Remove the 6 hub nuts and disc.