Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM1440E _54 Brake _056144 BRAKE (FRONT) _0274011 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 47732C 1.REMOVE FRONT DISC BRAKE SET RING

a.
C165347

Using a screwdriver, remove the 4 front disc brake set rings from the 4 cylinder boots.

HINT:

Tape the screwdriver tip before use.



Hide 2.REMOVE CYLINDER BOOT

a.

Using a screwdriver, remove the 4 cylinder boots from the disc brake cylinder.

HINT:

Tape the screwdriver tip before use.



Hide 47731 3.REMOVE FRONT DISC BRAKE PISTON

a.

Install one of the front disc brake pads.


b.
F042676E11
1.094,0.073 1.719,0.521 0.625,0.448 10 false 170 mm (6.70 in.) 2.729,0.135 3.333,0.49 0.604,0.354 10 false 50 mm (1.97 in.) 2.25,1.458 2.896,1.865 0.646,0.406 10 true 30 mm (1.18 in.)

Install a wooden plate between the front disc brake pistons of the disc brake cylinder to prevent the front disc brake pistons from jumping out.


c.

Using an air gun, gradually apply air and remove the 2 front disc brake pistons from the disc brake cylinder.

CAUTION:

Do not place your fingers in front of the piston when applying air.



d.
C172156E03
2.242,0.127 2.474,0.287 0.232,0.160 10 *1 1.602,0.407 1.602,0.206 1.602,0.206 2.198,0.206 false

Remove the front disc brake pad and wooden plate.

Text in Illustration
*1 Wooden Plate


e.

Temporarily install the 2 front disc brake pistons that were removed. Then install the front disc brake pad to the side in which the 2 front disc brake pistons are temporarily installed.


f.

Install a wooden plate between the front disc brake pistons of the disc brake cylinder to prevent the front disc brake pistons from jumping out.


g.

Using an air gun, gradually apply air and remove the 2 front disc brake pistons from the other side of the front disc brake cylinder.

CAUTION:

Do not place your fingers in front of the pistons when applying air.



Hide 4.REMOVE PISTON SEAL

a.
C165348

Using a screwdriver, remove the 4 piston seals from the disc brake cylinder.

HINT:

Tape the screwdriver tip before use.



Hide 31478B 5.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 47547B 6.REMOVE FRONT DISC BRAKE BLEEDER PLUG