Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
47547B
1.TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG
Temporarily install the front disc brake bleeder plug to the disc brake cylinder assembly.
The front disc brake bleeder plug will be tightened to the torque specification in the "Bleed Brake Line" procedure.
Install the front disc brake bleeder plug cap to the bleeder plug.
2.INSTALL PISTON SEAL
Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of 4 new piston seals.
| *1 | Lithium soap base glycol grease |
Install the 4 piston seals to the disc brake cylinder assembly.
47731
3.INSTALL FRONT DISC BRAKE PISTON
Apply a light coat of lithium soap base glycol grease to the entire inner circumference of 4 new cylinder boots.
| *1 | Lithium soap base glycol grease |
| *2 | Front Disc Brake Piston |
| *3 | Cylinder Boot |
Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the 4 front disc brake pistons where they contact the cylinder boots and front disc brake cylinder.
Install the 4 cylinder boots to the 4 front disc brake pistons.
Install the 4 front disc brake pistons to the front disc brake cylinder.
Do not forcibly install the piston into the disc brake cylinder.
4.INSTALL CYLINDER BOOT
Install one side of each of the 4 cylinder boots to the front disc brake cylinder.
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Set Ring |
Install the cylinder boot securely into the grooves of the disc brake cylinder and front disc brake piston.
Do not damage the cylinder boot.
47732C
5.INSTALL FRONT DISC BRAKE SET RING
Install the 4 front disc brake set rings.