Home › Brake › BRAKE (REAR) › REAR BRAKE
RM1440E _54 Brake _056145 BRAKE (REAR) _0274013 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash the brake fluid off immediately if it adheres to any painted surfaces.


Hide 47319F 3.DISCONNECT REAR FLEXIBLE HOSE LH

a.
F043125

Remove the union bolt and gasket from the rear disc brake cylinder, and then disconnect the flexible hose from the rear disc brake cylinder.

HINT:

Use a container to catch brake fluid as it drains out.



Hide 47750A 4.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH

a.
F043124

Remove the 2 cylinder slide pins from the rear disc brake cylinder.


b.

Remove the rear disc brake cylinder from the rear disc brake cylinder mounting.


Hide 04466 5.REMOVE REAR DISC BRAKE PAD

a.

Remove the 2 rear disc brake pads together with the rear disc brake anti-squeal shims from the rear disc brake cylinder mounting.


Hide 47744C 6.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM

a.

Remove the 2 rear disc brake anti-squeal shims from the rear disc brake pads.


Hide 7.REMOVE REAR DISC BRAKE WEAR INDICATOR PLATE

a.

Remove the rear disc brake pad wear indicator plate from the inner disc brake pad.


Hide 8.REMOVE REAR NO. 1 DISC BRAKE PAD SUPPORT PLATE

NOTICE:

If it is necessary to remove the pad support plates, replace them with new ones.


a.

Remove the 2 rear No. 1 disc brake pad support plates from the rear disc brake cylinder mounting.


Hide 9.REMOVE REAR NO. 2 DISC BRAKE PAD SUPPORT PLATE

NOTICE:

If it is necessary to remove the pad support plates, replace them with new ones.


a.

Remove the 2 rear No. 2 disc brake pad support plates from the rear disc brake cylinder mounting.


Hide 47722A 10.REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH

a.
F043126

Remove the 2 bolts, 2 plate washers and rear disc brake cylinder mounting.


Hide 47775D 11.REMOVE REAR DISC BRAKE BUSH DUST BOOT

a.

Remove the rear disc brake bush dust boot from the rear disc brake cylinder mounting.


Hide 47769A 12.REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH

a.

Remove the rear disc brake cylinder slide bush from the rear disc brake cylinder mounting.


Hide 47713A 13.REMOVE REAR DISC BRAKE CYLINDER HOLE PLUG

a.

Remove the rear disc brake cylinder hole plug from the rear disc brake cylinder mounting.


Hide 42431 14.REMOVE REAR DISC

a.
U116031E03
1.844,0.958 2.813,0.958 false 2.875,0.885 3.146,1.083 0.271,0.198 10 false *1

Place matchmarks on the rear disc and axle hub if planning to reuse the disc..

Text in Illustration
*1 Matchmark


b.
D028126

Turn the shoe adjuster until the disc turns freely, and then remove the disc

Text in Illustration
V100135

Shoe Adjuster Contracts
V100136

Shoe Adjuster Expands