Home › Brake › BRAKE (REAR) › REAR BRAKE
RM1440E _54 Brake _056145 BRAKE (REAR) _0274013 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE CYLINDER BOOT

a.
F043127

Using a screwdriver, remove the cylinder boot from the rear disc brake cylinder assembly.

HINT:

Tape the screwdriver tip before use.



Hide 2.REMOVE REAR DISC BRAKE PISTON

a.
F043128

Place a piece of cloth or a similar object between the rear disc brake piston and rear disc brake cylinder.


b.

Use compressed air to remove the rear disc brake piston from the rear disc brake cylinder.

CAUTION:

Do not place your fingers in front of the piston when using compressed air.


NOTICE:

Do not spatter the brake fluid.



Hide 3.REMOVE PISTON SEAL

a.
C213453

Using a screwdriver, remove the piston seal from the rear disc brake cylinder.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the inner cylinder or cylinder groove.



Hide 31478C 4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

Hide 47547C 5.REMOVE REAR DISC BRAKE BLEEDER PLUG

a.

Remove the bleeder plug cap and bleeder plug from the rear disc brake cylinder assembly.