Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  


DESCRIPTION

The power steering ECU assembly receives signals from the ECM, steering angle sensor and master cylinder solenoid (skid control ECU) via the CAN communication system.

DTC Code DTC Detection Condition Trouble Area
U0100 The engine speed signal is lost. CAN communication system
U0126 The steering angle signal is lost. CAN communication system
U0129 The vehicle speed signal is lost. CAN communication system

PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

b.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)