Home › Steering › STEERING COLUMN › STEERING WHEEL › 2009.08–2013.08
RM1440E _55 Steering _056148 STEERING COLUMN _0274024 STEERING WHEEL G

STEERING COLUMN  STEERING WHEEL  INSPECTION  


PROCEDURE

Hide 84250A 1.INSPECT STEERING PAD SWITCH ASSEMBLY

a.

Inspect the steering pad switch.

i.

Disconnect the switch connector.

C216959E03
1.729,2.208 1.333,1.573 1.333,1.573 1.063,1.573 true 2.042,2.167 1.677,1.021 1.677,1.021 1.396,1.021 true 1.719,2.469 1.365,3.073 1.365,3.073 1.094,3.073 true 1.771,2.708 1.396,3.49 1.396,3.49 1.125,3.49 true 2.063,2.49 2.49,3.052 2.49,3.052 2.708,3.052 true 5.406,2.188 5.74,1.646 5.74,1.646 5.938,1.646 true 5.042,2.229 4.604,2.531 4.604,2.531 4.427,2.531 true 4.99,2.604 4.688,3.094 4.688,3.094 4.49,3.094 true 4.99,0.938 5.302,0.375 5.302,0.375 5.396,0.375 true 5.01,1.146 5.156,1.333 5.156,1.333 5.25,1.333 true 4.875,1.146 5.073,1.604 5.073,1.604 5.167,1.604 true 4.75,1.156 4.635,1.594 4.635,1.594 4.563,1.594 true 2.771,3 3.021,3.219 0.25,0.219 10 false *1 1.219,0.927 1.396,1.115 0.177,0.188 10 false *3 0.906,2.99 1.083,3.177 0.177,0.188 10 false *2 0.875,1.49 1.083,1.667 0.208,0.177 10 false *4 0.969,3.396 1.167,3.583 0.198,0.188 10 false *5 4.25,2.458 4.479,2.646 0.229,0.188 10 false *6 5.969,1.583 6.167,1.76 0.198,0.177 10 false *8 4.281,3.021 4.49,3.219 0.208,0.198 10 false *7 5.479,0.281 5.917,0.458 0.438,0.177 10 false IL+2 4.26,1.51 4.698,1.688 0.438,0.177 10 false EAU 5.302,1.26 5.604,1.448 0.302,0.188 10 false AU1 5.24,1.542 5.573,1.729 0.333,0.188 10 false AU2

Text in Illustration
*1 Seek+ switch *2 Seek- switch
*3 Volume+ switch *4 Volume- switch
*5 MODE switch *6 Off Hook switch
*7 Voice switch *8 On Hook switch


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
10 (AU1) - 8 (EAU) No Switch pushed 95 to 105 kΩ
Seek+ Switch pushed Below 2.5 Ω
Seek- Switch pushed 313 to 345 Ω
Volume+ Switch pushed 950 to 1050 Ω
Volume- Switch pushed 2953 to 3265 Ω
9 (AU2) - 8 (EAU) No Switch pushed 95 to 105 kΩ
MODE Switch pushed Below 2.5 Ω
On Hook Switch pushed 313 to 345 Ω
Off Hook Switch pushed 950 to 1050 Ω
Voice Switch pushed 2953 to 3265 Ω


If the result is not as specified, replace the steering pad switch assembly.



b.

Check the illumination.

i.

Connect the battery positive (+) lead to terminal IL+2 and the negative (-) lead to terminal EAU of the steering pad switch assembly connector.


ii.

Check that the switch illumination comes on.

OK:

Steering pad switch illumination comes on.


If the result is not as specified, replace the steering pad switch assembly.