Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM1440E _55 Steering _056149 STEERING GEAR / LINKAGE _0274025 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY

a.
ZK08184

Install the nut.


b.

Flip the ball joint stud back and forth 5 times as shown in the illustration.


c.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and check the torque reading on the 5th turn.

Torque:

1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)



Hide 2.INSPECT TOTAL PRELOAD

a.
C216927E04
1.625,0.865 2.052,0.49 2.052,0.49 2.365,0.49 true 2.281,0.49 1.635,1.313 true 2.417,0.417 2.646,0.583 0.229,0.167 10 false *a

Place matchmarks as shown in the illustration.

Text in Illustration
*a Matchmark


b.

Temporarily install the 2 steering rack ends to the steering rack.

NOTICE:

Do not fully turn the steering rack without the steering rack ends installed as it may damage the oil seal in the rack housing.



c.
C215760E01
2.104,0.682 1.85,0.377 1.85,0.377 1.687,0.377 false 1.303,0.304 1.772,0.530 0.468,0.225 10 SST

Using SST, fully turn the steering rack right and left 10 times to settle it.

SST
09616-00011  


d.
C215761E01
2.115,0.67 2.008,0.288 2.008,0.288 1.848,0.288 false 1.481,0.208 1.808,0.364 0.327,0.156 10 SST

Using SST, turn the control valve and measure the preload.

SST
09616-00011  

Standard preload (turning):

1.6 to 2.3 N*m (16 to 23 kgf*cm, 14 to 20 in.*lbf)


If the turning torque is not as specified, replace the steering gear assembly.

HINT:
·

Measure the standard preload at the steering rack neutral point.

·

The steering control valve is fully turned when turned 3.00 times. Half of the distance from the fully turned position is the neutral point.




e.

After inspecting the preload, align the matchmarks.