When using a vise, do not overtighten it.
45047
1.REMOVE TIE ROD END SUB-ASSEMBLY LH
Put matchmarks on the tie rod end LH and steering rack end.
| *a | Matchmark |
| *b | Length A |
Measure length A and record the measurement.
Remove the tie rod end LH.
45046
2.REMOVE TIE ROD END SUB-ASSEMBLY RH
Use the same procedures described for the LH side.
3.REMOVE TURN PRESSURE TUBE
Using a union nut wrench, remove the turn pressure tube LH and RH.
44416
4.REMOVE STEERING GEAR OUTLET RETURN TUBE
Using a union nut wrench, remove the return tube from the steering gear.
5.REMOVE STEERING RACK BOOT CLIP LH
Using pliers, remove the steering rack boot clip.
6.REMOVE STEERING RACK BOOT CLIP RH
Use the same procedures described for the LH side.
7.REMOVE STEERING RACK BOOT CLAMP LH
Using pliers, remove the boot clamp as shown in the illustration.
Be careful not to damage the steering rack boot.
8.REMOVE STEERING RACK BOOT CLAMP RH
Use the same procedures described for the LH side.
45536
9.REMOVE NO. 2 STEERING RACK BOOT
Remove the steering rack boot.
45535
10.REMOVE NO. 1 STEERING RACK BOOT
Remove the steering rack boot.
44250
11.SECURE RACK AND PINION POWER STEERING GEAR ASSEMBLY
Using SST, secure the steering gear assembly.
Tape SST before use.
45503
12.REMOVE STEERING RACK END SUB-ASSEMBLY
Using SST, hold the steering rack (LH side).
| *A | LH Side |
| *B | RH Side |
| *a | Hold |
| *b | Turn |
Using SST, remove the steering rack end (LH side) from the steering rack.
Rotate SST in the direction shown in the illustration.
Using SST, remove the steering rack end (RH side) from the steering rack.
Rotate SST in the direction shown in the illustration.
Be sure to rotate SST in the correct direction.
Be sure to keep the steering rack fixed in place with SST.