Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E353056E01
4.708,2.063 5.021,2.26 0.313,0.198 10 false G29 2.625,1.573 3.865,1.917 1.24,0.344 10 false Parking Brake Switch Assembly 3.688,1.01 3.906,1.229 0.219,0.219 10 false 1 5.167,1.01 5.385,1.229 0.219,0.219 10 false 15 5.396,1.094 5.708,1.271 0.313,0.177 10 false PKB 4.719,2.219 7.073,2.427 2.354,0.208 10 false Radio and Display Receiver Assembly 2.625,1.427 2.938,1.625 0.313,0.198 10 false A2

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.




OK

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the G29 radio and display receiver assembly connector.


b.

Disconnect the A2 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G29-15 (PKB) - A2-1 Always Below 1 Ω
G29-15 (PKB) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR