Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Woofer Speaker Switch Circuit  


WIRING DIAGRAM

E195977E04
5.208,2.792 6.719,3.219 1.51,0.427 10 false Woofer Speaker Switch 2.427,2.021 3.25,2.292 0.823,0.271 10 false EQ RLY RH 3.438,1.531 4.833,1.865 1.396,0.333 10 false to Rear No. 2 Speaker Assembly RH 1.104,0.948 2.031,1.281 0.927,0.333 10 false to ACC Relay 0.094,1.333 2.052,1.667 1.958,0.333 10 false from Radio Receiver Assembly 0.479,1.781 2.135,2.115 1.656,0.333 10 false from Rear No. 1 Speaker Assembly RH 3.469,3.219 4.875,3.552 1.406,0.333 10 false to Rear No. 2 Speaker Assembly LH 1.156,2.625 2.083,2.958 0.927,0.333 10 false to ACC Relay 0.125,3.021 2.083,3.354 1.958,0.333 10 false from Radio Receiver Assembly 0.49,3.417 2.146,3.75 1.656,0.333 10 false from Rear No. 1 Speaker Assembly LH 2.438,3.698 3.24,3.958 0.802,0.26 10 false EQ RLY LH 5.208,2.625 6.292,2.802 1.083,0.177 10 false F27 5.542,2.385 5.865,2.563 0.323,0.177 10 false SW+ 6.083,2.375 6.406,2.552 0.323,0.177 10 false SW- 5.375,2.167 5.531,2.344 0.156,0.177 10 false 6 5.458,1.25 6.51,1.677 1.052,0.427 10 false Radio Receiver Assembly 5.458,1.083 5.667,1.26 0.208,0.177 10 false G9 5.563,0.688 5.885,0.865 0.323,0.177 10 false SW 5.365,0.583 5.521,0.76 0.156,0.177 10 false 1 6.448,2.167 6.594,2.344 0.146,0.177 10 false 3 3.052,0.844 3.188,1.021 0.135,0.177 10 false 1 3.052,1.417 3.188,1.594 0.135,0.177 10 false 3 2.458,1.229 2.594,1.406 0.135,0.177 10 false 5 2.458,0.865 2.594,1.042 0.135,0.177 10 false 2 2.458,1.635 2.594,1.813 0.135,0.177 10 false 4 3.052,2.521 3.188,2.698 0.135,0.177 10 false 1 3.052,3.104 3.188,3.281 0.135,0.177 10 false 3 2.458,2.896 2.594,3.073 0.135,0.177 10 false 5 2.458,2.521 2.594,2.698 0.135,0.177 10 false 2 2.458,3.292 2.594,3.469 0.135,0.177 10 false 4

PROCEDURE

1.INSPECT WOOFER SPEAKER SWITCH
a.
C185061E06
1.479,1.51 1.104,1.052 1.104,1.052 0.813,1.052 true 1.938,1.51 2.25,1.052 2.25,1.052 2.542,1.052 true 0.385,0.969 0.74,1.208 0.354,0.24 10 false SW+ 2.573,0.969 2.958,1.208 0.385,0.24 10 false SW-

Remove the woofer speaker switch (See page Audio / Visual / Telematics>AUDIO / VIDEO>WOOFER SPEAKER SWITCH>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (SW-) - 6 (SW+) Switch is pushed Below 1 Ω
3 (SW-) - 6 (SW+) Switch is not pushed 10 kΩ or higher




OK

2.CHECK RADIO RECEIVER ASSEMBLY

NG

2.CHECK RADIO RECEIVER ASSEMBLY
a.
U181035E02
2.271,1.188 2.563,1.01 2.563,1.01 2.719,1.01 true 0.031,0.042 0.5,0.229 0.469,0.188 10 false *a 2.76,0.938 3.083,1.125 0.323,0.188 10 false SW 1.604,0.438 1.938,0.625 0.333,0.188 10 false G9

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G9-1 (SW) - Body ground Audio system on, woofer speaker switch on Below 1 V
G9-1 (SW) - Body ground Audio system on, woofer speaker switch off 11 to 14 V


Text in Illustration
*a Component with harness connected
(Radio Receiver Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

3.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - WOOFER SPEAKER SWITCH)
3.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - WOOFER SPEAKER SWITCH)
a.

Disconnect the G9 radio receiver assembly connector.


b.

Disconnect the F27 woofer speaker switch connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G9-1 (SW) - F27-6 (SW+) Always Below 1 Ω
G9-1 (SW) - Body ground Always 10 kΩ or higher




OK

4.CHECK HARNESS AND CONNECTOR (WOOFER SPEAKER SWITCH - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (WOOFER SPEAKER SWITCH - BODY GROUND)
a.
U181032E02
1.448,1.396 1.635,1.844 1.635,1.844 2.031,1.844 true 2.083,1.729 2.438,1.938 0.354,0.208 10 false SW- 1.563,0.406 1.833,0.563 0.271,0.156 10 false F27 0.021,0 0.344,0.208 0.323,0.208 10 false *a

Disconnect the F27 woofer speaker switch connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F27-3 (SW-) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Woofer Speaker Switch)



OK

5.CHECK HARNESS AND CONNECTOR (WOOFER SPEAKER SWITCH - RELAY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK HARNESS AND CONNECTOR (WOOFER SPEAKER SWITCH - RELAY)
a.

Disconnect the F27 woofer speaker switch connector.


b.

Disconnect the relay connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F27-6 (SW+) - Relay-1 Always Below 1 Ω
F27-6 (SW+) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR