Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Portable Player cannot be Connected Manually/Automatically  


CAUTION / NOTICE / HINT

HINT:
·

Some versions of "Bluetooth" compatible audio players may not function, or the function using the radio receiver assembly may be limited even if the portable audio player itself can play files.


·

Refer to the Owner's Manual for the operating procedure.



PROCEDURE

1.CHECK CONNECTED DEVICE SETTINGS
a.

Check if the portable player is registered as a connected device.

NOTICE:

If a cellular phone is used as a portable player, it must be registered independently from the registration that is performed for the handsfree system.


Result
Result Proceed to
The portable player is registered as a connected device. A
The portable player is not registered as a connected device. B



A

2.CHECK SYMPTOMS

B

REGISTER PORTABLE PLAYER AS CONNECTED DEVICE

2.CHECK SYMPTOMS
a.

Check the connection condition between the portable player and radio receiver assembly.

HINT:
The portable player cannot be connected under any of the following conditions:
·

The portable player is connected to another device.

·

The portable player is connected to the radio receiver using the handsfree function.

·

The radio receiver has cleared the portable player registration.

·

The portable player is off.



Result
Result Proceed to
The portable player cannot connect automatically. A
The portable player cannot be connected manually. B



A

3.CHECK AUTOMATIC CONNECTION SETTINGS

B

4.CHECK PORTABLE PLAYER STATUS
3.CHECK AUTOMATIC CONNECTION SETTINGS
a.

Check the automatic connection settings of the "Bluetooth" audio.

i.

Turn the ignition switch off.


ii.

Turn the ignition switch to ACC or ON.

OK:

The portable player is automatically recognized by the radio receiver.





OK

4.CHECK PORTABLE PLAYER STATUS

NG

CHANGE SETTING TO ALLOW PORTABLE PLAYER TO BE RECOGNIZED BY RADIO RECEIVER

4.CHECK PORTABLE PLAYER STATUS
a.

Check the status of the portable player.

OK:

The portable player is in standby mode or connected to another device (headphones, etc.).




OK

5.CHECK USING ANOTHER "BLUETOOTH" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

NG

SET PORTABLE PLAYER TO STANDBY MODE AND DISCONNECT OTHER DEVICES (HEADPHONES, etc.)

5.CHECK USING ANOTHER "BLUETOOTH" AUDIO COMPATIBLE VEHICLE OF SAME MODEL
a.

Check if the portable player can be connected manually/automatically on another "Bluetooth" audio compatible vehicle of the same model.

OK:

The portable player can be connected manually/automatically.




OK

6.REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

NG

PORTABLE PLAYER IS NOT COMPATIBLE

6.REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES
a.

Remove additional devices which use radio waves.


b.

Check if the portable player can be connected manually/automatically.

OK:

The portable player can be connected manually/automatically.




OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE