| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| CB-43 | A non mass-storage class or USB device with an incompatible protocol is connected. | ·
USB device ·
Multi-media interface ECU |
| CB-44 | An incompatible file system or USB device with a corrupted or incompatible File Allocation Table (FAT) is connected. | |
| CB-50 | An "iPod" malfunction. | ·
"iPod" ·
Multi-media interface ECU |
| CB-51 | An "iPod" with unsupported firmware is connected. | |
| CB-7D | An unsupported model of "iPod" is connected. |
After the inspection is completed, clear the DTCs.
Disconnect the USB device or "iPod" from the stereo jack adapter.
Turn the ignition switch off.
When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter.
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
Refer to System Description for compatible formats and versions (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>SYSTEM DESCRIPTION).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs and check if the same DTC occurs again.
If DTCs are output frequently, replace the multi-media interface ECU.
Malfunction disappears.
OK
NG