| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| CB-45 | A communication error with the USB device. | ·
USB device ·
Multi-media interface ECU |
| CB-46 | An "iPod" control software malfunction. | ·
"iPod" ·
Multi-media interface ECU |
| CB-47 | A communication error with the "iPod". |
After the inspection is completed, clear the DTCs.
Disconnect the USB device or "iPod" from the stereo jack adapter.
Turn the ignition switch off.
When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter.
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs and check if the same DTC occurs again.
If DTCs are output frequently, replace the multi-media interface ECU.
Malfunction disappears.
OK
NG