Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU  


DESCRIPTION

The multi-media interface ECU sends sound signals to the radio receiver assembly through this circuit.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly or speakers.

WIRING DIAGRAM

E199620E01
0.96,0.589 1.366,0.773 0.406,0.184 10 USD1 0.96,1.049 1.393,1.219 0.434,0.170 10 URO+ 0.96,1.509 1.352,1.656 0.392,0.147 10 URO- 0.96,2 1.347,2.174 0.387,0.174 10 ULO+ 0.96,2.471 1.359,2.652 0.400,0.182 10 ULO- 1.49,0.482 1.666,0.668 0.177,0.186 10 1 1.49,0.963 1.665,1.138 0.176,0.176 10 2 1.49,1.43 1.646,1.586 0.156,0.156 10 3 1.49,1.909 1.612,2.131 0.122,0.223 10 4 1.49,2.383 1.599,2.576 0.110,0.193 10 5 0.483,2.948 0.815,3.122 0.332,0.174 10 G11 0.483,3.135 2.167,3.300 1.684,0.165 10 Multi-media Interface ECU 5.637,0.496 5.814,0.682 0.177,0.186 10 1 5.637,0.977 5.812,1.153 0.176,0.176 10 2 5.637,1.444 5.793,1.600 0.156,0.156 10 3 5.637,1.923 5.759,2.145 0.122,0.223 10 4 5.637,2.397 5.747,2.590 0.110,0.193 10 5 5.779,2.943 6.037,3.090 0.258,0.147 10 G8 5.779,3.121 6.806,3.443 1.026,0.323 10 Radio Receiver Assembly 3.327,2.775 3.942,2.940 0.614,0.165 10 Shielded 5.849,0.589 6.255,0.773 0.406,0.184 10 CSLD 5.849,1.049 6.283,1.219 0.434,0.170 10 CDR+ 5.849,1.509 6.241,1.656 0.392,0.147 10 CDR- 5.849,2 6.237,2.174 0.387,0.174 10 CDL+ 5.849,2.471 6.249,2.652 0.400,0.182 10 CDL-

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - RADIO RECEIVER)
a.

Disconnect the G11 multi-media interface ECU connector.


b.

Disconnect the G8 radio receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G11-1 (USD1) - G8-1 (CSLD) Always Below 1 Ω
G11-2 (URO+) - G8-2 (CDR+) Always Below 1 Ω
G11-3 (URO-) - G8-3 (CDR-) Always Below 1 Ω
G11-4 (ULO+) - G8-4 (CDL+) Always Below 1 Ω
G11-5 (ULO-) - G8-5 (CDL-) Always Below 1 Ω
G11-1 (USD1) - Body ground Always 10 kΩ or higher
G11-2 (URO+) - Body ground Always 10 kΩ or higher
G11-3 (URO-) - Body ground Always 10 kΩ or higher
G11-4 (ULO+) - Body ground Always 10 kΩ or higher
G11-5 (ULO-) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR