Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2009.08–2012.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  USB Device or "iPod" cannot Charge  


WIRING DIAGRAM

E353050E01
0.927,2.104 3.219,2.333 2.292,0.229 10 false No. 2 Stereo Jack Adapter Assembly 0.927,1.927 1.292,2.135 0.365,0.208 10 false G26 2.188,0.448 2.323,0.667 0.135,0.219 10 false 1 4.844,0.458 4.979,0.677 0.135,0.219 10 false 1 2.188,1.302 2.323,1.521 0.135,0.219 10 false 4 4.823,1.323 4.958,1.542 0.135,0.219 10 false 4 4.854,1.938 5.219,2.146 0.365,0.208 10 false G27 4.854,2.104 6.5,2.292 1.646,0.188 10 false Multi-media Interface ECU

PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the stereo jack adapter.


b.

Turn the ignition switch off.

HINT:

When this malfunction occurs, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.



c.

Turn the ignition switch to ACC.


d.

Connect a known good USB device or "iPod" to the stereo jack adapter.

OK:

USB device or "iPod" charges.




OK

USB DEVICE OR "iPod" WAS DEFECTIVE

NG

2.CHECK MULTI-MEDIA INTERFACE ECU
2.CHECK MULTI-MEDIA INTERFACE ECU
a.
U181030E03
0.042,0 0.292,0.188 0.25,0.188 10 false *a 1.594,0.417 1.927,0.604 0.333,0.188 10 false G26

Disconnect the G26 No. 2 stereo jack adapter assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G26-1 - G26-4 Always 5 V


Text in Illustration
*a Front view of wire harness connector
(to No. 2 Stereo Jack Adapter Assembly)



OK

REPLACE NO. 2 STEREO JACK ADAPTER ASSEMBLY

NG

3.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER)
3.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER)
a.

Disconnect the G27 multi-media interface ECU connector.


b.

Disconnect the G26 No. 2 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G27-1 - G26-1 Always Below 1 Ω
G27-4 - G26-4 Always Below 1 Ω
G27-1 - Body ground Always 10 kΩ or higher
G27-4 - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR