Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2013.08–2015.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E280687E12
0.875,0.646 1.25,0.823 0.375,0.177 10 false UDO- 0.844,1.406 1.25,1.583 0.406,0.177 10 false UDO+ 0.875,2.229 1.25,2.406 0.375,0.177 10 false UJSS 1.302,2.083 1.458,2.26 0.156,0.177 10 false 5 1.323,1.302 1.479,1.479 0.156,0.177 10 false 3 1.313,0.521 1.469,0.698 0.156,0.177 10 false 2 0.365,2.688 0.708,2.865 0.344,0.177 10 false G31 0.344,2.833 1.5,3.177 1.156,0.344 10 false No. 1 Stereo Jack Adapter Assembly 3.271,2.365 3.917,2.542 0.646,0.177 10 false (Shielded) 5.708,0.49 5.865,0.667 0.156,0.177 10 false 2 5.719,1.323 5.875,1.5 0.156,0.177 10 false 3 5.708,2.115 5.865,2.292 0.156,0.177 10 false 5 5.927,0.615 6.26,0.792 0.333,0.177 10 false US1- 5.938,1.427 6.302,1.604 0.365,0.177 10 false US1+ 5.927,2.198 6.323,2.375 0.396,0.177 10 false USG1 5.802,2.646 6.146,2.823 0.344,0.177 10 false G32 5.781,2.823 7,3.198 1.219,0.375 10 false Radio and Display Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the G32 radio and display receiver assembly connector.


b.

Disconnect the G31 No. 1 stereo jack adapter assembly connector.


c.
U181090E02
2.365,1.646 1.844,1.406 true 1.083,1.646 1.604,1.406 true 2.302,1.771 1.781,1.542 true 1.625,3.427 1.104,3.188 true 1.771,3.417 2.281,3.177 true 2.281,3.823 1.771,3.51 true 1.594,0.177 1.885,0.333 0.292,0.156 10 false G32 2.406,1.583 2.865,1.771 0.458,0.188 10 false US1- 0.615,1.604 1.073,1.792 0.458,0.188 10 false US1+ 2.313,1.792 2.771,1.979 0.458,0.188 10 false USG1 1.615,2.333 1.906,2.49 0.292,0.156 10 false G31 0.74,3.042 1.198,3.229 0.458,0.188 10 false UDO- 2.365,3.063 2.823,3.25 0.458,0.188 10 false UDO+ 2.354,3.781 2.813,3.969 0.458,0.188 10 false UJSS 0.188,0.094 0.354,0.26 0.167,0.167 10 false *a 0.188,2.156 0.385,2.323 0.198,0.167 10 false *b

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G32-2 (US1-) - G31-2 (UDO-) Always Below 1 Ω
G32-3 (US1+) - G31-3 (UDO+) Always Below 1 Ω
G32-5 (USG1) - G31-5 (UJSS) Always Below 1 Ω
G31-2 (UDO-) - Body ground Always 10 kΩ or higher
G31-3 (UDO+) - Body ground Always 10 kΩ or higher
G31-5 (UJSS) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR