Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2013.08–2015.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Display Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E283444E03
5.698,2.49 6.104,2.698 0.406,0.208 10 false G29 5.979,0.844 6.51,1.052 0.531,0.208 10 false VV+ 5.698,0.771 5.885,0.979 0.188,0.208 10 false 13 5.969,1.458 6.5,1.667 0.531,0.208 10 false VV- 5.719,1.375 5.906,1.583 0.188,0.208 10 false 14 5.958,2.021 6.49,2.229 0.531,0.208 10 false SG 5.698,1.958 5.885,2.167 0.188,0.208 10 false 12 0.948,0.865 1.25,1.073 0.302,0.208 10 false VV+ 0.958,1.479 1.219,1.688 0.26,0.208 10 false VV- 1.313,0.771 1.5,0.979 0.188,0.208 10 false 6 1.302,1.333 1.49,1.542 0.188,0.208 10 false 11 5.698,2.635 7.01,3.052 1.313,0.417 10 false Radio and Display Receiver Assembly 0.24,2.49 0.604,2.698 0.365,0.208 10 false G31 0.25,2.625 1.563,3.042 1.313,0.417 10 false No. 1 Stereo Jack Adapter Assembly 2.26,2.208 2.979,2.396 0.719,0.188 10 false Shielded 4.146,2.219 4.865,2.406 0.719,0.188 10 false Shielded

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the G29 radio and display receiver assembly connector.


b.

Disconnect the G31 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G29-13 (VV+) - G31-6 (VV+) Always Below 1 Ω
G29-14 (VV-) - G31-11 (VV-)
G29-13 (VV+) - Body ground Always 10 kΩ or higher
G29-14 (VV-) - Body ground
G29-12 (SG) - Body ground




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR