86309B
1.INSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY
Install the antenna pole by hand until fully seated.
| *a | 1/8 turn (20 to 45 degrees) |
Using a 8 mm (5/16 inch) wrench, fully tighten the radio antenna pole about 1/8 turn (20 to 45 degrees) by turning it clockwise.
Do not over tighten. Tighten with finger, not hand.
Do not use pliers to tighten the radio antenna pole as it can leave marks on the radio antenna pole surface.
The antenna pole cannot be hand tightened to the proper specification.