86171B
1.INSPECT WOOFER SPEAKER SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (SW-) - 6 (SW+) | Switch is pushed | Below 1 Ω |
| 3 (SW-) - 6 (SW+) | Switch is not pushed | 10 kΩ or higher |
If the result is not as specified, replace the woofer speaker switch.
85912D
2.INSPECT RELAY (EQ RLY LH Relay, EQ RLY RH Relay)
Remove the relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | Battery voltage is not applied between terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | 10 kΩ or higher | |
| 3 - 4 | Battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω |
If the result is not as specified, replace the relay.