Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056151 PARK ASSIST / MONITORING _0274042 REAR VIEW MONITOR SYSTEM U

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  TERMINALS OF ECU  


CHECK INNER REAR VIEW MIRROR ASSEMBLY


U181015E02
3.51,0.146 3.781,0.323 0.271,0.177 10 false S5

a.

Disconnect the S5 inner rear view mirror assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
S5-1 (IG) - S5-2 (E) L - W-B Ignition switch signal Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
S5-2 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the S5 inner rear view mirror assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
S5-3 (REV) - S5-2 (E) R - W-B Reverse signal Ignition switch ON, shift lever in R 11 to 14 V
Ignition switch ON, shift lever not in R Below 1 V
S5-6 (CV-) - Body ground B - Body ground Shielding Always Below 1 V
S5-7 (CV+) - S5-6 (CV-) W - B Display signal Ignition switch ON, shift lever in R Pulse generation
(See waveform 1)
Ignition switch ON, shift lever in R, screen blacked out by covering camera lens Pulse generation
(See waveform 2)
S5-14 (CB+) - S5-13 (CGND) R - Shielded Power source Ignition switch ON, shift lever in R 5.5 to 7.05 V

If the result is not as specified, the inner rear view mirror assembly may have a malfunction.


e.
E159949E01
0.196,1.018 0.531,1.161 0.335,0.144 10 GND

Using an oscilloscope, check waveform 1.

Measurement Condition
Item Content
Terminal No. (Symbol) S5-7 (CV+) - S5-6 (CV-)
Tool Setting 0.2 V/DIV., 50 μs/DIV.
Condition Ignition switch ON, shift lever in R


f.
E164781E01
0.275,1.002 0.612,1.146 0.336,0.144 10 GND

Using an oscilloscope, check waveform 2.

Measurement Condition
Item Content
Terminal No. (Symbol) S5-7 (CV+) - S5-6 (CV-)
Tool Setting 0.2 V/DIV., 50 μs/DIV.
Condition Ignition switch ON, shift lever in R, screen blacked out by covering camera lens