The inner rear view mirror assembly receives a reverse signal from the park/neutral position switch assembly.
Disconnect the S5 inner rear view mirror assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S5-3 (REV) - Body ground | Ignition switch ON, shift lever in R | 11 to 14 V |
| S5-3 (REV) - Body ground | Ignition switch ON, shift lever in not R | Below 1 V |
| *a | Front view of wire harness connector
(to Inner Rear View Mirror Assembly) |
OK
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE)
NG
Disconnect the S5 inner rear view mirror assembly connector.
Disconnect the B42 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S5-3 (REV) - B42-1 (RL) | Always | Below 1 Ω |
| S5-3 (REV) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (for A750E) | A |
| OK (for A750F) | B |
| NG | C |
A
(See pageDrivetrain>A750E AUTOMATIC TRANSMISSION / TRANSAXLE>PARK / NEUTRAL POSITION SWITCH>REMOVAL)
B
(See pageDrivetrain>A750F AUTOMATIC TRANSMISSION / TRANSAXLE>PARK / NEUTRAL POSITION SWITCH>REMOVAL)
C